 |
 |
 |
 |
|
|
 |
 |
|
|
 |
 |
|
|
 |
|
 25 Jan 2006, 8:53 PM
|
jim2000
Joined on 01-14-2006
Posts 105
|
|
I will try that and I want to know how to define the size of a drill. I can define a via, but it only show the ths size of its pad and I don't know how to define the drill.
Thanks
Jim
Forum: Basic PCB Design
Posted: : Wednesday, January 25, 2006 11:54 AM [GMT -5]
Post Subject: : Re: The fanout and Capacitors Ron_O wrote: | Not sure I follow your problem exactly but sounds like you have vias that are disappearing when you route. You could try using Freevias to prevent this -press the E key when you want to insert a freevia.
Ron O.
|
|
|
|
|
|
|
|
|
|
|
26 Jan 2006, 8:19 AM
|
cseltzer
Joined on 06-11-2002
Largo, FL
Posts 853
|
|
Jim,
In the padstack spreadsheet there are two rows, "DRILL" and "DRLDWG". Set both of these to the size of the drill that you want to use. The only selection for pad shape for these two rows is round or undefined since the drill can only be round if it is used.
Good luck,
Chris Seltzer
|
|
| |
|
|
|
|
|
|
|
|
OrCAD Community » OrCAD Community Forums » Basic PCB Design » Thank you very much
|
|
|
|